Owners
Alfen Eve
This guide shows where to paste, in your brand’s portal or tool, the three values Naudo sends you. Nothing to configure in the Naudo app.
Where to configure
ACE Service Installer (Windows), on the same network as the charger. Backoffice config is usually done via ACE.
Fields to fill in
Back office URL / ocppCsmsUrl
URL provided by Naudo. Depending on firmware, Alfen may append the identity to a base URL wss://ocpp.naudo.be/ocpp.
information provided by Naudo
Customer Ident. number / ChargeBox Identity
information provided by Naudo
Password / auth
information provided by Naudo
Naudo URL format : wss://ocpp.naudo.be/ocpp/{identity}
If the brand screen asks for a protocol, choose OCPP 1.6 (JSON / WebSocket).
Steps
- Launch ACE Service Installer and connect to the charger.
- Connectivity tab.
- Under Back office, choose Manually enter Backoffice settings (not an Alfen or other operator preset).
- Enable a Network Profile (priority 1), protocol OCPP 1.6 (JSON), then paste URL, Identity and password (information provided by Naudo).
- General tab: Customer Ident. number = Naudo Identity.
- Save and reboot if asked, then Naudo online confirmation.
How you know it worked
- You save or reboot the charger in the brand tool.
- The charger connects to Naudo (often within a few minutes).
- Naudo confirms the charger is online, or you see it after a Start / Stop test on a booking.
Easee, Tesla Wall Connector Gen 3, Ohme and Schneider EVlink Home: no owner CSMS URL to paste as below — those chargers stay outside this procedure (manual mode or another path).